Civil Engineering Test
__________ is a line which joins subsidiary stations with the main line.
__________ is the portion of a wall which is used to support an arch.
__________ is used/done to check the strength of the concrete by virtue of the sound it makes.
___________ is an assembly of over-lapping photographs.
___________ is an obstruction in the bed of a stream in order to make the water flow into a nearby channel.
___________ is carried out to determine the safety bond stress between concrete and steel.
___________ is the branch of hydrology which deals with the moisture content in the soil.
___________ is the distance between two adjacent trusses.
___________ is the extension of the wall above the roof level.
___________ is used to establish a benchmark.
___________ line joins the vertices of the trusses.
____________ is called the undersurface of a stair.
____________ is the ratio of the weight of the soil solids to the volume of the soil mass.
____________ is the value of sensitivity of a rigid module.
____________ when water is added to the cement.
_____________ is the process of addition of a layer of cement mortar to the surface of concrete.
________________ is the line having zero declination.
A canal must be aligned along the ___________ for optimum utilization.
A cement is unfit for use if it absorbs moisture in excess of ________.
A curve headed groin is known as __________.
A pressure hypsometer works on the phenomena:
A sextant is a device capable of measuring angles up to _____.
A squint junction is:
Calculate the length which must be embedded in order to develop a resistance equal to the tensile pull in a steel rod having a diameter of 20 millimeters, when the value of maximum permissible tens...
For a building, the wind pressure and wind velocity are related as:
For constructing a structure in water, we use a type of stone that possesses the ability to float on water. What is it called?
If M is the bending moment, E is the modulus of elasticity and I is the polar moment of Inertia then, what is the value of the strain energy stored by an elastic member which is subjected to bending?
If the run-off coefficient of an area is 0.20 and the total rainfall in that area is 20 centimeters, calculate the run off.
In a concrete slab, the value of the reinforcement is taken as ___.
In a constant head parameter test of 5 minutes duration, the quantity of water collected is 450 milliliters. Calculate the discharge per unit time.
In a joint, the number of rivets required is calculated by using the formula ____________.
In a steel structure, what is an under-reinforced section?
In a two way slab, the reinforcement is provided:
In an RCC structure, the value of modular ratio for design is _______.
In which among the following methods of calculating the runoff consumption is the estimation of the rain water absorbed by the soil carried out?
The _________ helps in reducing the shrinkage of concrete.
The above given symbol is used for indicating:
The beams which support the stair steps are known as:
The deformation of a hot brick when water falls on it is known as _______.
The factor of safety of a building is:
The heat generated by the cement when it hardens is known as __________.
The mass specific gravity of soil in its dry state is known as:
The maximum amount of eccentricity load that can be applied on a rectangular foundation having width 'd' is:
The minimum value of factor of safety of a plain concrete retaining wall is __.
The most effective method of curing of concrete is :
The process of mixing sand in natural soil in order to improve the quality of soil is known as _____.
The re-designing of an RC beam is usually done when its shear stress exceeds _________.
The slenderness ratio of a compression structural member is :
The soil which offers minimum resistance to the flow of electric current is known as _______.
The strap efficiency of a reservoir is a function of:
The structure which is used to support a vertical cladding is known as ____________.
The toughness index of soil is:
The value of the Poisson's ratio for concrete lies between:
The volume of a specimen of soil is 20 cubic centimeters and its weight is 50 grams. Calculate the volumetric shrinkage if the volume of dry specimen is 10 cubic centimeters.
The weight of the furniture kept inside a building is classified as:
What is percolation coefficient?
What is the average value of creep coefficient of cement concrete?
What is the intensity of the active earth pressure at a depth of 10 meters, given that the coefficient of active earth pressure is 3 and the unit weight of dry sand is 2 tonnes per cubic meter?
What is the value of the angle of intersection of a contour and a ridge line?
What is the value of the angle of the penetrating cone in a static penetrometer test?
What is the value of the effective depth of a T-beam for heavy loads?
What is the value of the minimum depth for laying foundations below the ground level?
What is the value of the radius of a 1° circular curve?
What is the value of the slope of the angle of a stair?
What is the value of the uniformity coefficient of soil?
Which among the following methods is used to determine the water content of coarse grained soils?
Which among the following methods is used to solve three-point problem?
Which among the following tests of field identification of soils consists of the sieving process?
Which form of lime among the following hardens due to the absorption of carbon dioxide in the atmosphere?
Which grade of brick can withstand below freezing temperatures in moist climate?
Which of the following equipments are used for distance measurement.
Which of the following is used for making building materials capable of withstanding temperature of 773.15 Kelvin?
Which type of cement among the following is capable of withstanding high temperatures?
Which type of cement has a final setting time of 30 minutes?
Which type of joint is used to make wooden floors?
Which type of surveying method is used to ascertain the quantities of dredged material?